Two Nerf Stryfe Mod 145fps 100fps Oj Dart Zone Dart Compatible Kriss Vector

1st Nerf stryfe mod average 145fps. Meishel 2.0 motors. Worker 15 round magazine. 3d printed petg 42.5mm cage. 3d printed expanded battery door, rev trigger, mag release, trigger under under barrel picatinny rail, stock butt plate and top barrel cover. 18awg wiring with 15 amp switch and xt60 connector. 2nd Nerf stryfe mod 102fps. Kriss Vector body kit. 43mm daybreak flywheel cage. This blaster runs on AA batteries for ease of use I do recommend using energizer lithium’s for a longer lasting battery but works no problem on nice Duracell AA BATTERIES. Blaster is averaging 145 fps with freshly charged 7.4 2s lipo (which is not included) and fresh dart zone chili darts. Due to pla 3d printed parts, the blaster should not be left in hot car or direct sunlight for extended periods of time because parts may warp. These are not toys and should not be treated like ones. Blasters should be fully revved before firing or motor damage could occur. Incorrect darts could also cause motor damage do not use cheap knockoff nerf darts. Dart zone chili darts are recommended for best performance.